For many commercial and industrial projects in Perth, the pressure is on choosing a hot water system that suits the site properly from the outset. ELWA manufactures high-efficiency instantaneous hot water systems for commercial and industrial applications, including new-build apartment projects. We help plumbers, electricians, hydraulic engineers, consultants, builders, project managers, and facilities managers select the right Hot water system. This guidance is based on building layout, expected demand, available power, and compliance requirements.
When hot water is selected on assumptions rather than site realities, problems tend to follow. The available power may not suit the selected system, outlet demand may be higher or more varied than expected, and delivery temperature requirements can also be harder to meet when inlet conditions and usage patterns have not been reviewed properly.
ELWA is Australian-owned, with its central office in Adelaide, a supporting team in every state, and Western Australian support through its Osborne Park location. We bring more than 35 years of Hot Run water heating experience, along with WA project experience across sites such as Dumas House in Perth, Kalgoorlie Courthouse, Cunderdin Football Club, the Wheatstone Project in Onslow, John Septimus Roe Anglican Community School, and Perth Stadium.
For Perth commercial buildings and facilities, ELWA can help bring clearer direction around:
This gives project teams a more practical basis for choosing the right system before procurement and installation begin.
For many Perth buildings and facilities, the goal is to find a hot water system that is efficient, compact, and practical for the way the site actually operates.
The ELWA Hot Run X range is designed for commercial applications where on-demand performance, flexible electrical options, and careful system selection all matter. Key benefits include:
The strongest system selections usually come from understanding the application properly before ordering begins.
Review the outlet types, the number of outlets, and whether usage is likely to be intermittent, continuous, or simultaneous across the site.
Check whether the site has single-, two- or three-phase power available, along with the usable load.
Peak draw-off, inlet water temperature, and the target delivery temperature all affect how the system should be selected.
In some applications, placing hot water closer to the point of use can improve response time and reduce unnecessary water and heat loss.
Floor plans, schedules, and service details give ELWA a clearer basis for guiding system selection and directing the project through the appropriate plumbing or electrical distributor.
Working through these points early can help reduce system changes, support commissioning, and give project teams clearer information before installation begins.
If your Perth project needs an electric hot water system that is better matched to commercial demand, available power, and the building layout, it makes sense to narrow the selection before procurement begins. Share the project details with ELWA and we can help identify the most suitable Hot Run X model and configuration for the application.
Yes, depending on the model selected and the site conditions. Smaller Hot Run X models suit handwash basins, kitchenettes, and single outlets, while larger three-phase models are designed to serve multiple basins, showers, and kitchen sinks. The final choice still depends on inlet water conditions, required flow, and available power.
Yes. ELWA Hot water systems can be considered for new-build apartment projects where compact design, on-demand performance, and careful system selection are important. The right model depends on the building layout, electrical capacity, fixture schedule, and required delivery temperature.
Placement affects response time, water wastage, and heat loss. In some applications, locating hot water closer to the point of use can reduce long pipe runs and improve day-to-day performance. Whether that approach suits the site depends on the building layout and the way hot water is used.
ELWA manufactures the systems, while supply is handled through plumbing and electrical distributors. We can assist with product guidance and technical information so the selected Hot water system is better matched to the project requirements.
FOR ALL ENQUIRIES PLEASE GET IN TOUCH WITH US
Specialising in the design, manufacturing and installation of innovative LED lighting and electric water heating solutions.
Call: +61 8 8377 6666
Monday – Friday: 8am–5pm (AEST)